INM Crystal, Inc.
Pearl and Crystal Necklace
(Project ID : NE-CREAM-303)

Pearl and Crystal Necklace
Item quantities below show the number of packs of each item that would be needed to create this piece of jewelry. Please note: if you click 'Buy Now' after one item, you will be adding ALL of the items below to your shopping cart in the quantities indicated in the Buy Now boxes below. If you do not want to purchase all the items below, please adjust the quantities of packs in the Buy Now boxes to fit your needs and then click 'Buy Now' when you have completed ordering the components for this jewelry item.

Product
Image
Stock
Status
Product Number Items
Per Pack
Price
Level 1
Price
Level 2
Price
Level 3
Buy Now
Out of Stock BPSS-G24-200
Sterling Silver Headpins 2mm Ball Ends
2 1-4
$2.46 
5-9
$2.32 
10+
$2.20 
Out of Stock HPSS-G24-200
Sterling Silver Headpins Gauge 24 - 2"
10 1-4
$2.50 
5-9
$2.37 
10+
$2.24 
Out of Stock JUMP-SS-47
Jump Rings - Open 4.7mm Sterling
25 1-2
$4.50 
3-4
$4.25 
5+
$4.05 
Out of Stock SCBF-F8-26
Figure Eight Chain Chain Not Returnable
1 1-3
$4.22 
4-6
$4.00 
7+
$3.78 
In Stock SS-BC-45-H
Sterling Silver 4.5mm Bead Caps
20 1-4
$3.20 
5-9
$3.04 
10+
$2.86 
Out of Stock SWHH-R22
Sterling Wire Half Hard - 22 Gauge
1 1-1
$25.30 
2-2
$24.04 
3+
$22.77 
In Stock TRG-8-SS
Sterling Silver 8mm Trigger Clasps
10 1-2
$6.90 
3-4
$6.50 
5+
$6.20 

Guide
Wire Wrap

One:
Cut seven 1" sections, two 1/2" sections, and one 3" sections of the chain

Two:
String the beads for the dangle on a headpin and make a wrapped loop. Put this dangle on a jump ring.

Three:
Cut eight 3" lengths of wire. String on a 4mm pearl, 5mm crystal, beadcap, 7mm pearl, beadcap, 5mm crystal, and 4mm pearl. Make half of a wrapped loop at each end of the wire.

Four:
Connect the two 1/2" sections of chain to the jump ring with the dangle, forming the center of the necklace.

Five:
Attach the beaded wires to the chain sections and complete the wrapped loops.

Six:
Attach the trigger clasp to the remaining 1" section of chain with a jump ring.

Seven:
Attach the 3" section of chain to the remaining beaded section with a jump ring so the length of the necklace can be adjusted.

Eight:
Add a decorative dangle at the end of the chain, if desired.

Nine:
Please note that this necklace was originally made with 7mm cream pearls which have since been discontinued. We have replaced them in our item list with 8mm cream pearls.
All content is copyrighted material.
All use, reproduction and/or publication rights reserved worldwide.
Web Design/Content Copyright (C) 1999 - 2020 INM Crystal, Inc.
All Images Copyright (C) 1999 - 2020 INM Crystal, Inc. Solar