INM Crystal, Inc.
Hint of Spring Necklace
(Project ID : NE-VI-593)

Hint of Spring Necklace
Item quantities below show the number of packs of each item that would be needed to create this piece of jewelry. Please note: if you click 'Buy Now' after one item, you will be adding ALL of the items below to your shopping cart in the quantities indicated in the Buy Now boxes below. If you do not want to purchase all the items below, please adjust the quantities of packs in the Buy Now boxes to fit your needs and then click 'Buy Now' when you have completed ordering the components for this jewelry item.

Product
Image
Stock
Status
Product Number Items
Per Pack
Price
Level 1
Price
Level 2
Price
Level 3
Buy Now
Out of Stock BWG-S-24
Beadwire Silver - 24 Gauge
12 1-2
$4.08 
3-4
$3.87 
5+
$3.66 
Out of Stock JUMP-SS-47
Jump Rings - Open 4.7mm Sterling
25 1-2
$4.50 
3-4
$4.25 
5+
$4.05 
Out of Stock SCBF-LCC-25
Long Curb Chain Chain Not Returnable
1 1-2
$5.48 
3-4
$5.19 
5+
$4.90 
In Stock TRG-8-SS
Sterling Silver 8mm Trigger Clasps
10 1-2
$6.90 
3-4
$6.50 
5+
$6.20 

Matching Idea
Hint of Spring Bracelet
Hint of Spring Earrings

Guide
Wire Wrap

One:
The directions for the netted flower components can be found in the book, "Crystal Brilliance," item #BK-CB.

Two:
The book contains instructions for a bracelet, and we made the following changes to make this necklace.

Three:
For the center stitched component, we started with seven 4mm bicones instead of 5, and used two groups of seven 3mm bicones as well. The seed bead counts remained the same.

Four:
We stitched the square shaped loop at each end of the stitched component, and added a jump ring to attach the chain.

Five:
After stitching the middle component, cut six 3/4 inch length of chain and two 3 inch lengths of chain.

Six:
Make the wire wrapped components using the 24 gauge beadwire, bicones and seed beads.

Seven:
Attach the wire wrapped components to the chain, and add the trigger clasp.

Eight:
Please note: this necklace measures 17 inches and we used approximately 11 inches of chain to make it. If you want to make the necklace longer than 18 inches, you will need to order 2 feet of chain.

Nine:
Note: our original design called for 3mm bicones in Violet Opal AB, which has been discontinued. We have replaced it with 3mm Violet Opal bicones.
All content is copyrighted material.
All use, reproduction and/or publication rights reserved worldwide.
Web Design/Content Copyright (C) 1999 - 2020 INM Crystal, Inc.
All Images Copyright (C) 1999 - 2020 INM Crystal, Inc. Solar